Home/ Questions/Q 88217
Next
In Process

Answerclub Latest Questions

kavyashree
  • 0
  • 0
Knowledge Contributor
Asked: 2024-06-02T18:38:23+05:30 In:

When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?

  • 0
  • 0
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?

1 Answer

  1. kavyashree
    Knowledge Contributor

    The clock rate command is used to specify the speed of the serial connection between two routers. This command is used only on the DCE end of the connection. The clock rate command is used in the following format: Router(config-if)# clock rate [speed in bps]

You must login to add an answer.

Need An Account,